Big block conversion question.

[steve69]

I just bought a Big Block conversion for my micro, just for a laugh you understand, it's just a toy to use in the offices at work on the weekends, large amounts of carpet in the board rooms and the like.
Is it OK to run it on a 7.2v pack that I made?
And which pinion do you think would be best, I have a 11t and 13t both in steel?

Any suggestions apreciated.

Thanks

Steve

[Matt]

Originally posted by steve69
I just bought a Big Block conversion for my micro, just for a laugh you understand, it's just a toy to use in the offices at work on the weekends, large amounts of carpet in the board rooms and the like.
Is it OK to run it on a 7.2v pack that I made?
And which pinion do you think would be best, I have a 11t and 13t both in steel?

Any suggestions apreciated.

Thanks

Steve

I think you've got more money than sense :rolleyes:
The board room at weekends !!!!!!!!
They pay you for this?......lol
Wow :D

[steve69]

I think you've got more money than sense
Still not as much money as you tho matt :p

The board room at weekends !!!!!!!!
They pay you for this?......lol
Cool huh? Just dont tell anyone! :D

[hpiadmin]

I was tempted for a big block for my micro.

If you want extreme speed I have actually seen a brushless motor
that fits in the micro !!

I would need a set of wheels on the roof for that though :D

[phatman]

I only put the motor in at the weekend and have only run it in the house,

Well, I say run it... Crashed it into everything is probably a better description,

It is just sooooo funny to watch it accelerate down my hallway and disapear into the kitchen in such a short time you have no control at all, you just have to make sure you are pointing in the right direction( or perhaps I could learn about throttle control?..............Nah!)